I've seen some threads on here about relays for the driver's window, but I thought I'd describe my issue to see if anyone knows what I need to look at first. The driver's window would go down just fine, but it started to have problems going back up. For a little while I could hold the switch in the up position for several seconds and then it would finally start going up. Eventually, it got to the point where that no longer worked and the window is stuck in the down position. I initially thought the switch had gone bad since I was getting a voltage reading when the switch was held in the down position, but not the up position. I installed a new switch and it still will not go up. Does anyone know if the motor could be bad, or does it sound like a relay problem?