Hey all,
In an effort to get my reverse lights working again, I’ve disassembled and cleaned my NSS (neutral safety switch) with some electronic cleaner from CRC per another threads recommendation.
After cleaning the parts and scrubbing down the exterior, I remounted it and when I went to start it, I got full lights on the dash, but no starter engagement or click.
I repeated the cleaning and mounting process with no luck.
Could it be in the wrong position when I’m putting it back? (see the photos below for the position I’ve been remounting in)
I’ve also looked at the contacts on the lever and the they seem a bit flush or low. The plate contacts also seem a bit worn.
Could I have damaged the switch when cleaning? Or is it too worn? It was starting just fine before I underwent this process, so I’m a little confused.
I’ve added pictures below of the state of things.
In an effort to get my reverse lights working again, I’ve disassembled and cleaned my NSS (neutral safety switch) with some electronic cleaner from CRC per another threads recommendation.
After cleaning the parts and scrubbing down the exterior, I remounted it and when I went to start it, I got full lights on the dash, but no starter engagement or click.
I repeated the cleaning and mounting process with no luck.
Could it be in the wrong position when I’m putting it back? (see the photos below for the position I’ve been remounting in)
I’ve also looked at the contacts on the lever and the they seem a bit flush or low. The plate contacts also seem a bit worn.
Could I have damaged the switch when cleaning? Or is it too worn? It was starting just fine before I underwent this process, so I’m a little confused.
I’ve added pictures below of the state of things.
Last edited:
