PabloCruise
SILVER Star
Back at it!
Looks like you are just in time before the plants took it over...
Looks like you are just in time before the plants took it over...
FJ55 Heavy Duty
- Thread starter landcrusiergod1
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #182
Yes, lots of side quests on this adventure
- Thread starter
- #183
Crank handle mod to the press
- Thread starter
- #184
Side quest- making a new gate for the dog groomer next door. These are the side panels, gate door in the middle. Wood router made short work of the aluminum.
- Thread starter
- #185
Side quest is almost done! Doggie door for the groomer across the street.
- Thread starter
- #186
Cruiser content was the hinges … from an fj40 doors
- Thread starter
- #187
Safety blue
- Thread starter
- #188
Rear floor was replaced with steel plate. Christmas Eve update. Merry Christmas everybody
- Thread starter
- #189
More
- Thread starter
- #190
Made a press break out of some scraps, still moving forward…
What’s the cable over the top for again?
- Thread starter
- #192
To raise and lower the bar for each hole.
- Thread starter
- #193
Got to close the loop for one of the FJ55’s I moved a few years ago. These doors were on marketplace just north of Atlanta. I asked if he was going to the beach for the holidays. Yep, PCB! Drove over and picked them up. It was great to meet you, and share stories. Doors will be donors to repair mine.
- Thread starter
- #195
Removed the rear seat - the attached parts were still there. Picked up the bender off of marketplace, never used. 1.75 tube die … just have to remove the front seats and the top will come off. Happy new year
- Thread starter
- #196
Marketplace score - chromolly.
- Thread starter
- #197
Presto change-o- ! Roof is off. The frame looks okayish. Some pin holes - but over all salvageable!
- Thread starter
- #198
Just a mock up of the chromolly cage. A little massage and it will do nicely. It will be on the inside, of course. Clean up now and attack again ! 2024 yee haw!
- Thread starter
- #199
Dual motor 8274, still in mock up phase. Almost ready to burn it in. A couple more days of testing and fitting.
- Thread starter
- #200
I could use the search - but anyone have pictures of an interior cage?
