FJ40 clutch fork installation

[j_lowder]

After a seized 2F engine (failed oil pump), I have received my rebuilt engine. I installed the engine and 4 speed transmission. I did not install the clutch fork as I thought I recalled its removal prior to removal of the engine and transmission.

Now after approximately 2 hours, a couple of beverages, and a few choice words, I been been unsuccessful in getting the clutch fork reinstalled.

Did I make a blunder which can only be corrected by separation of the engine and transmission or is there a trick to installation from my current situation?

Thanks for input.

 

[Mr. Toad]

I thought about this before I installed my transmission a couple months ago. I could not think of a way to get the Y through the hole with the transmission in place, so i decided the best thing would be to stick it thru the hole from the inside, with the pivot bolt removed, and mount the tranny. I'm sorry, this is no help.

 

[shelfboy1]

ive done it before several times with the tranny in the truck,im pretty sure the pivot had to be removed to make it fit .good luck

 

[j_lowder]

Thanks for the input.

I'll try again in about a week (I need a break from the frustration). I still think that I removed the clutch fork prior to separating the engine and transmission. If not, this will be one of many tough learning experiences.

 

[grant5127]

ive done it before several times with the tranny in the truck,im pretty sure the pivot had to be removed to make it fit .good luck

I wager the top t/o brg. hub clip was a bitch to get in, or did you just leave it out ?