EDIC problems (1 Viewer)

[Sherman Tank]

All you need for the OI is a small pivot near the IP , so you can use a cable instead of a rigid rod, when you pull the cable, the lever is pushing on the " over injection "
A carburator spring can be hooked to the lever to make the pull knub spring loaded

But, is the OI doing something different than the gas pedal?

 

[hj 60]

Hi this topic below might explain more, I think over inject gives more fuel, not more air like throttle (very noticable when glowers are worn, the over inject just cools the bad glowing and more smoke with no or bad starting)

3B EDIC Overinjection position advances timing?

When i had my 3b on the engine stand i experimented with the fuel control arm and found that in the over injection position it advances the timing. now my question is am I making things up here or has anyone else found this as well. Also i set my fuel screw just before it starts to advance and...

forum.ih8mud.com