Hi have problem with Edic motor BJ42 at 24v. the car will not stop, in the beginning I address the problem to the Edic relay, but I have test it on other truck and work fine. Today I have opened the motor, cleaned the contact and renewed the grease. I test it but was working reverse, instead to move forward in order to shut the fuel it was going in OI. I open it again and move the gear arm inside. And now as I connect the motor to the plug the relay continuously sound (click-clack) and the motor obviously not move. Some one have procedure to test the motor without connect to the car harness and how to position the gear and the arm inside? Thanks a lot
Last edited:
