Builds cuttin up the lx (1 Viewer)
- Thread starter wv_lx450
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #162
Last edited:
- Thread starter
- #163
used these EMP clamps that are for SXS windshields
- Thread starter
- #165
yep. mr10 (margard, i believe)
- Thread starter
- #166
Last edited:
No cup holders?
- Thread starter
- #169
ha, none yet. ill figure that out later lol.
- Thread starter
- #171
yes, he is very particular about the work he does.
Love the lexan idea. I just installed lexan (unbreakable) with the same clamp system on my Polaris Ranger Crew. What are is your plan for the spot between the roof and windshield?
- Thread starter
- #173
gonna bring the almuminum down all the way to just on the lexan so the water will run off onto the windshield
- Thread starter
- #174
Last edited:
looks really good... i'm going to be trying to do something similar, but with my roof on 
...
...Looks nice.
A thought for you: From a rollover crush perspective, the section behind the front seats isn't doing much for you without lower links. At a minimum I would throw in a vertical tub in the center where they all meet.
A thought for you: From a rollover crush perspective, the section behind the front seats isn't doing much for you without lower links. At a minimum I would throw in a vertical tub in the center where they all meet.
- Thread starter
- #177
it will have two more tubes coming down from the center to the bottom tube, just didnt get them in yet.
- Thread starter
- #178
looks really good... i'm going to be trying to do something similar, but with my roof on
that will be a fun project lol. i know the guy working on mine is ready to see it go. it has worn him out doing this one even with no roof.
Wrench
One Bashed Up 80
When an 80 rolls all the weight is on the A pillars. The B pillars hardly feel any weight. What he has now would be adequate in a roll over.
- Thread starter
- #180
Last edited:
