Creative replacement for rear gate stopper assy? (1 Viewer)

[Toyo_Judson]

Looking for what the rest of MUD has done to replace the stopper assy, rear swing gate.

I've come up with the following PNs:
68950-60010
68950-90300
68950-90305

Looks like:

 

[rkymtnflyfisher]

Didn't @oldschool4wheeling have an ace in the hole on that part?

Or was there someone else that had some in the classifieds?

 

[Toyo_Judson]

Didn't @oldschool4wheeling have an ace in the hole on that part?

Or was there someone else that had some in the classifieds?

looking...

 

[rkymtnflyfisher]

For Sale - Barn / half door bolt / barrel latches (Taking orders)

I sent a request on Thursday asking for a pm. I would like to buy a pin for my 73 FJ. Please respond. Thanks

forum.ih8mud.com

 

[65swb45]

For Sale - Section 157-Saloon door latch pins

Fit the 64-74 rear 'saloon' style rear doors. $20 each, until they're gone. No plans to make more. Minimum order requirements apply. No PMs please.

forum.ih8mud.com

 

[rkymtnflyfisher]

For Sale - Section 157-Saloon door latch pins

Fit the 64-74 rear 'saloon' style rear doors. $20 each, until they're gone. No plans to make more. Minimum order requirements apply. No PMs please.

forum.ih8mud.com

My memory is coming back now.

 

[Toyo_Judson]

So Mark @65swb45 , you have the pin itself?

 

[Toyo_Judson]

@65swb45, I just read through the entire post... I'll call you tomorrow.

 

[thebigredrocker]

I think Mark's also repopped the pin housing, but he may be sold out. Look's like he definitely has pins.

 

[Trialsallday]

if you get the pin from mark, just thread a screw into the side. i cut the head off mine and welded a ball bearing. get a cheap pack of assorted springs from home depot and slide one of them inside as well. also drilled my tub and inserted a brass bushing to receive the pin since my tub was for ambi doors.