rear door stopper (1 Viewer)

[Shmanwell]

Bonjour
Je précise que je suis français et je vous demande de m'excuser pour les fautes que je vais commettre.
Je cherche la pièce entourée en rouge sur les pièces jointes. Il est introuvable en France. Auriez-vous une adresse où je pourrais le trouver ?
Remercier

 

[B y r o n]

Translated:

"Good morning
I specify that I am French and I ask you to excuse me for the errors which I will make.
I'm looking for the piece circled in red on the attachments. It cannot be found in France. Do you have an address where I could find it?
Thank"

 

[JeffD]

May be hard to find, but you can check with Spector off road.

Land Cruiser Rear Swing Out Door 1958-1974 40 Series

Land Cruiser 40 Series Rear Door Swing-Out, tailgate, 1958-1974, latches, hinges, weather strip

www.sor.com

 

[65swb45]

@kevos37 has the reproduction pins. I should know: I sold them to him.

 

[kevos37]

Bonjour
Je précise que je suis français et je vous demande de m'excuser pour les fautes que je vais commettre.
Je cherche la pièce entourée en rouge sur les pièces jointes. Il est introuvable en France. Auriez-vous une adresse où je pourrais le trouver ?
Remercier

View attachment 3319482

View attachment 3319483

j'ai le boîtier et la broche. pas de poignée

 

[Shmanwell]

Merci pour vos réponses.
Chez SOR cette pièce semble indisponible.
kevos37 peux tu mettre une photo des pièces car malheureusement avec la traduction automatique j'ai du mal à comprendre ?

 

[Shmanwell]

Thank you for your answers.
At SOR this part seems unavailable.
kevos37 can you put a photo of the parts because unfortunately with the automatic translation I have trouble understanding?

 

[kevos37]

Thank you for your answers.
At SOR this part seems unavailable.
kevos37 can you put a photo of the parts because unfortunately with the automatic translation I have trouble understanding?

Will do tomorrow

 

[Living in the Past]

Will do tomorrow

Is this just the pin or the whole unit? If the small handle with the threaded end is definitely interested myself.


Years ago someone made these assembly. Was only a few and possibly just one. I know I bought one just haven't seen on years.

 

[Shmanwell]

I'm looking for everything

 

[kevos37]

Here is what i currently have.

On the top is a oem pin spring and housing. No threaded handle.

Bottom aftermarket pin and catch.

I do not have any threaded handles at this time.

Cheers,
KevO

 

[Living in the Past]

I do not have any threaded handles at this time.
View attachment 3320309

I really should figure out the thread diameter/pitch and find a more accurate bolt versus the SAE screw in there now.


Come across a handle I would like one for my 68.

 

[kevos37]

The pitch is 6mm x 1.0. I did have this suggestion for a handle.

 

[Living in the Past]

The pitch is 6mm x 1.0. I did have this suggestion for a handle.

View attachment 3320357View attachment 3320360

Looks like it would hold up better than what Toyota originally used.

 

[Shmanwell]

Great I'm interested. How to proceed ?