Hi all, so here is what I have. I have a good functioning carb fan, a new spal thermosensor and a new round relay.
1) When all connected, and when I attach the battery cables the fan turns on and just runs...and runs and runs.
2) with battery connected and carb fan disconnected, the round relay is hot. not good.
3) I suspect that perhaps the circuit board relay is bad somewhere.
Would someone with a keen eye take a look at the photos and tell me if you see anything that would indicate some failure on this part (outside of the ability to test individual components). I'm not an electrics guy; the solder points look solid, but there is some gunk on there which might be interfering. If it's a matter of just cleaning it, great. if not, I may go the InPower relay route and ditch the two stock relays.
Anyway, as always, any observations are appreciated.
1) When all connected, and when I attach the battery cables the fan turns on and just runs...and runs and runs.
2) with battery connected and carb fan disconnected, the round relay is hot. not good.
3) I suspect that perhaps the circuit board relay is bad somewhere.
Would someone with a keen eye take a look at the photos and tell me if you see anything that would indicate some failure on this part (outside of the ability to test individual components). I'm not an electrics guy; the solder points look solid, but there is some gunk on there which might be interfering. If it's a matter of just cleaning it, great. if not, I may go the InPower relay route and ditch the two stock relays.
Anyway, as always, any observations are appreciated.