Hi need some advice, please.
My breakfluid reservoir started leaking where the stud joins the master cylinder. Obviously I rocked it too much in my effort to clamp a pressure- bleeding device to the lid.
- Anyone an idea how to disassemble this and how to seal it?
Neither workshop manual nor parts catalog clearly show a gasket or seal in this place. All I can see is part reference 47202T / 9056218151 called 'Ring'. Is that the seal?
How is the reservoir fixed in place? I suppose this 47231 is bolt with a bore that I need to undo from within the reservoir?
Anything else to observe?
Thanks for any advice
Best regards Ralf
My breakfluid reservoir started leaking where the stud joins the master cylinder. Obviously I rocked it too much in my effort to clamp a pressure- bleeding device to the lid.
- Anyone an idea how to disassemble this and how to seal it?
Neither workshop manual nor parts catalog clearly show a gasket or seal in this place. All I can see is part reference 47202T / 9056218151 called 'Ring'. Is that the seal?
How is the reservoir fixed in place? I suppose this 47231 is bolt with a bore that I need to undo from within the reservoir?
Anything else to observe?
Thanks for any advice
Best regards Ralf