I searched some time ago and don’t remember finding anything on these so I bought some 1/16” neoprene and got busy.
The trigger was that my left directional wasn’t blinking which turned out not to have a ground wire. When I remove the signal I found it bolted straight to the fender. That was the start of things for this.
I’ve got a precision cad cutting table so it is a nice break from the grease of this hobby.
Since starting with the signal lights I moved on to the door hinges and the hood hinges are next. And suggestions where to go next are greatly appreciated.
The trigger was that my left directional wasn’t blinking which turned out not to have a ground wire. When I remove the signal I found it bolted straight to the fender. That was the start of things for this.
I’ve got a precision cad cutting table so it is a nice break from the grease of this hobby.
Since starting with the signal lights I moved on to the door hinges and the hood hinges are next. And suggestions where to go next are greatly appreciated.