- Thread starter
- #541
I had similar process with Teseven 1/2 tub yesterday. The rear door opening was not straight at all, 10 mm difference from the bottom to the up, within only 365 mm distance.
So, jacking up time.
View attachment 2206631
Now it match and door
I had similar process with Teseven 1/2 tub yesterday. The rear door opening was not straight at all, 10 mm difference from the bottom to the up, within only 365 mm distance.
Hey Matti, looking good. I have to say overall the tub is good but there were some fitment issues that’s for sure. I see you have the weatherstrip channel on your 1/2 tub. Fabien builds them like that now but mine was an early model so I don’t have it. I could weld it in but I feel that it would be weakening the corners where the outside sheet metal meets the corner. So I have opted not to cut and go with the overlap like Teseven recommends