Over the weekend I installed an Avid rear bumper with dual swing arms. 80% of the effort involved removing the original pieces, cutting 3.5” off the end of the frame, and cleaning up the old weld lines. Once that was complete the installation went very smoothly. I don’t have a lot of experience with such parts, but I am an aerospace engineer, and this was a quality piece of work.
Only one mild gripe … they did not include new mounting fasteners. The old ones kind of work but they really should have bigger heads and beefier washers. I found a great selection of such stuff at Belmetric and will swap them into the vehicle when they arrive.
Only one mild gripe … they did not include new mounting fasteners. The old ones kind of work but they really should have bigger heads and beefier washers. I found a great selection of such stuff at Belmetric and will swap them into the vehicle when they arrive.