Okay so after a lot of research my brain is dead trying to figure this out on my own.
Currently, I have the OME 2.5 medium-lift with the 851 springs in the front. Plans have a front bumper, winch in the future. Would the 850J be too much after the added weight, would the front still sit higher than the rear? The approximate weight added on after the bumper and winch would be an additional 150lbs roughly.
Also, I do plan on adding some plate to the top of the bumper to give it a more finished look too and possibly mount my high lift mount on the bumper also.
Or should I go with the Slee 20mm rubber spacer in the front, it should add approximately 3/4". But the issue there is eventual sagging after some time.
Everyone here is in my mind an expert, compared to myself.
Currently, I have the OME 2.5 medium-lift with the 851 springs in the front. Plans have a front bumper, winch in the future. Would the 850J be too much after the added weight, would the front still sit higher than the rear? The approximate weight added on after the bumper and winch would be an additional 150lbs roughly.
Also, I do plan on adding some plate to the top of the bumper to give it a more finished look too and possibly mount my high lift mount on the bumper also.
Or should I go with the Slee 20mm rubber spacer in the front, it should add approximately 3/4". But the issue there is eventual sagging after some time.
Everyone here is in my mind an expert, compared to myself.