fjfar80
GOLD Star
80 Series General Tech and Classifieds (7 Viewers)
- Thread starter MEMCruiser
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
yall are nuts....leather is da bomb
Or... You could have the leather on non-electric seats and have the best of both. More leg room and sit a bit lower on these seats taking up space in my shop.... Somebody need to make me an offer on these! Just think- no more plastic plugs to chase around.
Do they fit in the same 4 bolt holes as the electric seats?
Bomar
SILVER Star
wngrog said:
Yes...there is no mounting difference.
NOW its an 80 section
Leather vs cloth ..serious stuff there ; )
Leather vs cloth ..serious stuff there ; )
Damn right!
Ok, serious tech. Michaela's 80 is having a brake problem that has my guys stumped.
Nolen was driving it the other day and noticed it and i have several times as well.
In normal stopping you have a good pedal, but in panic stopping you apply the brakes and the pedal just stiffen ups like normal but it continues to roll. Its like the abs is not engaging right. No lights, bleed brakes and had very little air out of right rear. But pedal acts normal in regular stopping. Strange...
Bomar
SILVER Star
wct49 said:
Is there a way to test the booster? Maybe at hard stops loosing pressure
booster gonna give you a hard pedal, stupid hard when failing, right?
Bomar
SILVER Star
wct49 said:
I am probably 1k% wrong just thinking out loud.
Land Speeder
InstaH8R
Did you bleed LSPV too?
Probably ABS or master
Either way its nolan's fault..
Probably ABS or master
Either way its nolan's fault..
Not sure, but is there a vacuum line to the booster? May wanna make sure it's crack free and in good order.
Like JBo, I'm thinking aloud...
Like JBo, I'm thinking aloud...
nope, didnt bleed lspv. but other than panic stops has a good pedal.
if its a abs control module failure or a sensor, on most vehiles you get an abs light on in the dash. this truck has no light on.
I'm leaning toward a weak master but its again not acting like a normal failure.
Land Speeder
InstaH8R
there are vacuum lines to the booster, just make sure they aren't cracked, etc.
I rebuilt a MC and it was stupid easy. Toyota sells a rebuild kit.
I rebuilt a MC and it was stupid easy. Toyota sells a rebuild kit.
Vacuum lines look good. Boys in shop are leaning toward a weak booster.
Land Speeder
InstaH8R
Think it might be a caliper maybe getting stuck? That would cause it to be good during a slight braking motion but the caliper hanging up if forced hard.... kinda your symptoms. I bet they're due for service anyway.
Bodean
Hot Damn
Damn the brakes! What about the air!?
Mine is doing the same thing. I ordered a master cylinder and booster. Found rear seal on master cylinder has failed and leaking into the booster.
Now I am ready !!!!
I have fabbed up the most important mod for any trail trip, road trip or just hanging out.
Very durable
Versatile
It even cuts down on domestic disputes..
Its a.......
MF'n cupholder... made of steel..
I have fabbed up the most important mod for any trail trip, road trip or just hanging out.
Very durable
Versatile
It even cuts down on domestic disputes..
Its a.......
MF'n cupholder... made of steel..
