that answers that .. thank you .
200 Series and Tundra wheels on 100 series photo thread (1 Viewer)
- Thread starter krice118
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
that answers that .. thank you .
merbesfield
SILVER Star
looks good. Why the spacers? Did they push the wheels out too far? Any rubbing issues?
spacer needed to clear center cap but min 1" . I went w the 1.25 and gave the look i wanted. Slight rub but heated the inner fender liner and ur good. Doesnt rub on fender
merbesfield
SILVER Star
Can the inside of wheels be milled slightly to clear caps?
It's the wheel cap that hits the dust cover. You can either run without center caps, bash in dust cover or run spacers.
Sounds like the wheel’s hub bore is tapered and would need to be machined to fit over the hub.... but that’s next level sh*t compared to flattening the grease cap so the plastic center caps can snap on.
Your correct ..the TRD pro rims are tapered in the center bore hole, not allowing the hub to fit through ..the center caps had nothing to do with it on my 1999 LX470.
Not sure if the ones everyone else (including me) are running are also trd pro wheels. I'm guessing you have the newest trd pro BBS wheels. Love those wheels but it's sad to hear they changed the design to make it difficult for us.
Last edited:
- Thread starter
- #969
I didn’t feel like messing with front center caps. Painted the hub black.
this is what I am up against with the 2020/2021 TRD pro wheels . I hope you can see the tapper in the photos . I don’t have a inner caliper or any calipers to read it with right now .. but by using my standard tape and converting the measurements ..it goes from 110 mm to about 90 mm at the narrowest section and then proceeds to open back up for the cap to catch a lip .
Last edited:
They came with the steelies, I found them on my local OfferUp. There should be some for sale for shipping.
Figured I could contribute here. 275/70R18 KO2s. 1.25" Bora spacers.
w/o vs with spacers
How my spare fits in w/ stock hitch. I couldn't go with more that a 275/70 and still store a full spare here. When it was first installed, it was rubbing the panhard bar.
I have the same color LX .. lookin good with that setup . I just ordered the Bora 1.25” spacers for mine . I hope it’s not a 2 week wait .
Ahhhh the PNW drizzle outside your garage .. I don’t moss it a bit ... yet .
My 05 LX470 with Tundra wheels.
Good question. I'm not aware of any 17 tundra wheels that match this description.
GTV
SILVER Star
The only 17” Tundra wheels are the Rock Warriors.
I just received my Bora spacers on Friday. I ordered them on October 6th and got them On November 11th. So 5 weeks. YMMV
lstamatis
Overland Traveler
What size tire are you running? Doesn't look like you have spacers. Any rubbing?
