FAQ 1st Gen Tacoma FAQ's (1 Viewer)

[yotadude520]

I figured I would make a thread that compiles a ton of information about common mods and issues on the Tacoma.

Manual Hub Conversion:

Manual locking hubs on Tacoma...worth it? stay tuned

I finally broke down and went for it. I ordered all the parts I needed last week and got around to doing it. I have seen multiple "how to" articles on this topic and not one did the job from start to finish on their own. The hard part for me is over and my knuckle assemblies are ready for...

forum.ih8mud.com

2004 convert to manual hubs

Hi guys - I've googled the heck out of this and haven't been able to find an answer. Every thread I've read on converting ADD equipped trucks to manual front hubs talks about swapping in the front knuckles from a manual hub truck into the ADD truck, then replacing the hubs and axles with...

forum.ih8mud.com

locking hub conversion for taco

Has anyone done a manual locking hub conversion for a tacoma. I am lookin into swapping out my 01 ADD system to manual hubs. I am looking for as much info as I can find, pics, ideas, changes, mods, ect.

forum.ih8mud.com

Supercharger Info:

First gen supercharger rebuild kit

Hi guys, The SC is sounding a little raspy on this new to me tacoma and figure quarantine is a good time to dig into it. Dunno when it was service last. Is there a decent kit you would recommend to service these grey SCs? I’ve found a few on EBay, but I am completely new to forced induction...

forum.ih8mud.com

1st Gen Taco (95-04)

1st Generation Toyota Tacoma

forum.ih8mud.com

5vz-FE Supercharger leaking at the bypass valve elbow

I think that's what its called, by bypass valve elbow. Been pulling a P0171 Code for a lean condition. Sprayed some starter fluid around the supercharger and found the idle changed pretty drastically when I sprayed around the elbow for the bypass valve. It actually moves quite a bit when you...

forum.ih8mud.com

E85 and Supercharger?

Hey, looking for some advice. Is it possible to run E85 in a supercharged V6 4Runner? For context, the previous owner upgraded the fuel pump and injectors in this truck. I don't have any pinging under any condition, so I'm assuming he did it right. With 91 octane hovering around $4/gallon...

forum.ih8mud.com

SAS Info:

Taco SAS question

Okay, so if you do an SAS on a Tacoma, and you're planning on running an '85 front axle and doubled up mini t-cases, could you just buy a Taco prerunner, or are the transmissions different? It seems like if you're planning on cutting out all the front end stuff and using a different t-case, you...

forum.ih8mud.com

tacoma2002's SAS Thread

After much anticipation (and parts collection) I'm now ready to begin a build thread here for my ride. I've had the truck since 2004 and it has undergone many phases in its time. It started with a Corn Fed spacer lift (some of you will get a chuckle if you remember that guy) and AAL with...

forum.ih8mud.com

80 series axles+suspension under a Tacoma

I have wanted 80 series axles under a 1st Gen Tacoma for years and spent a lot of time thinking about this (Even since back in about 2009 when I was in a 3rd Gen 4Runner cause I wanted 80s axles under my 4Runner) but I think it would just about be the perfect setup if the Tacoma had 80 series...

forum.ih8mud.com

Taco SAS question

Okay, so if you do an SAS on a Tacoma, and you're planning on running an '85 front axle and doubled up mini t-cases, could you just buy a Taco prerunner, or are the transmissions different? It seems like if you're planning on cutting out all the front end stuff and using a different t-case, you...

forum.ih8mud.com

Prerunner 4x4 Conversion:

Taco prerunner to 4x4 conversion, what parts would I need?

Title says it all

forum.ih8mud.com

Builds - Back In Business: Ferg's Tacoma Build

NEW TACOMA - 08/2016 - current I've taken over my old Tacoma thread with the new Tacoma. :D They're just about the same truck anyway, other than color and the new one (red one) came as a 4x4 so I didn't have to convert it. :D Here's what it was like the day it arrived: 2003 Toyota Tacoma...

forum.ih8mud.com

Builds - 2004 Tacoma PreRunner 4x4 Conversion & Build Thread

A while ago I bought a 2000 Tacoma PreRunner with a 2.7l to get me by while my 1987 was getting painted. Ended up really liking the comfort & drivability of the 1st gen Tacos and decided to sell that one and get a newer one with a V6. A few months ago I ended up finding a 2004 Tacoma PreRunner...

forum.ih8mud.com

5VZ-FE Issues/Diagnosis:

3.4 Liter 5VZ-FE Engine Replacement

Howdy Dudes, If you were looking for a tutorial on how to swap out your 3.4 liter engine, we've got a video series that can help you out. It's divided into 4 Parts. Part 1 covers how to remove the old engine from your vehicle. Part 2 covers stripping down the old motor of the parts you need to...

forum.ih8mud.com

Need Advice / Likely Blown Head Gasket / '02 Taco / 5VZ-FE

I'm not sure where to go first so here's the story. Maybe 5-6+ months ago I had a major overheat and had very low coolant and low oil. Topped off each and was good to go until about a week ago. CEL goes on and I get code P0300 for random cylinder misfire and P0303 for cylinder #3 misfire...

forum.ih8mud.com

Transmission Info:

2004 Tacoma ATF spec

Hello, I just picked up a 2004 Tacoma with an Automatic. It did not come with the owners manual so I was wondering if someone could tell me if the transmission takes Dex-III or the Toyota T-IV. I've read conflicting information on the interwebs.

forum.ih8mud.com

Auto Trans Shifter Bushing Replacement & Transfer Case Shifter Seat Replacement

Well Howdy My 3rd Gen 4runner & 1st Gen Tacoma Brothers and Sisters, my buddy Sean and I have another video for you. If you've got a wobbly Auto Trans Shifter and you're getting tired of it, this video will show you how to replace the bushings so you can tighten it back up to a brand new...

forum.ih8mud.com

Flex plate issues.

I haven't torn it down yet but sure I have lost the second flex plate in the (new to me) 2001. The PO just replaced the original with an aftermarket unit. All the symptoms, slight ticking that gets louder, and total loss of (like dropping into neutral) function while climbing a grade and...

forum.ih8mud.com

Suspension:

Collapsed suspension. What to replace with?

I think my front passenger side suspension broke. Truck is sitting about a 1/4" from the front bump stop on that side. Driver side is about 1" from the bump stop. Was thinking that when the suspension went I would use the chance to upgrade it a bit. Can I do only the fronts IFS coilovers? Or...

forum.ih8mud.com

80 series springs

I thought I've heard 80 series stock springs can be used to lift a 4R or Taco. I couldn't find anything on the search, would anyone mind clarifying this for me? Thanks.

forum.ih8mud.com

2003 Toyota suspension questions

Hey all. I am looking at a 2003 Taco. Its not the TRD package BUT it is 4x4 and the semi elusive color, white. other than going ARB package deal ($1,200) route, whathave you guys been using to get about 2" lift onto your tacos? also, other than frame issues, what are the big things to look out...

forum.ih8mud.com

This is just a start and I will add more threads as I have time - if you have a thread that you would like added to the list, PM me and I will get it on there!