I am replacing the clutch in my 1970 FJ-40 3-speed. I took the flywheel to a shop to have it resurfaced. He did not have any specific specs to go by, but simply took the same amount off both of the step surfaces. The difference between the two surfaces is .755. Does anyone know if this is within tolerances?
1970 flywheel specs. (2 Viewers)
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Doesn't seem like a good machine shop that doesn't know what the spec's are for the job IMHO.
forum.ih8mud.com
Flywheel step measurments.... ( FAQ )
These are the step measurements on the F style flywheel and the 2F style flywheel... F Flywheel uses the three-finger pressure plate. .630" step or 16.002mm 2f Flywheel uses the diaphragm style pressure plate. .020" step or .508mm 2F Flywheel for the diaphragm style clutch...
forum.ih8mud.com
- Thread starter
- #3
Thanks Charlie. That's what I was looking for!Doesn't seem like a good machine shop that doesn't know what the spec's are for the job IMHO.
Flywheel step measurments.... ( FAQ )
These are the step measurements on the F style flywheel and the 2F style flywheel... F Flywheel uses the three-finger pressure plate. .630" step or 16.002mm 2f Flywheel uses the diaphragm style pressure plate. .020" step or .508mm 2F Flywheel for the diaphragm style clutch...
