measurement

I've read several references on 'mud of two different generations of front drive flanges on the 80. I'd like to locate a set for trail spares, but I want to buy the correct version. Is there a measurement that I could take on my current flanges to determine which version to buy? I can't just...

Updated: This is for Trouble code C1AC1 Master Module Horizontal Axis Misalignment; This also displays "Check BSM System" on dash monitor. If you trimmed plastic like me, get into mud, and then don't clean it all out... This will likely happen to you! These are NOT the 4 round parking sensors...

LX570. every frigin time i take a dipstick reading it is off +/- a quart. a week ago, it showed i was way low. Added 3/4 quart, and it just barely made it up to where it indicates. Checked again 2 days later, and it was below the reading level, so i added a full quart. then a week later i...

Anybody in their rig with a tape? I'd love to have the handle to handle measurement for the bench seat area. Hook the tape on the handle and measure to the outside of the opposite door handle. I'll pay in candy corn! TIA - Rob

Hi !! I have a friend who wants to make his long rear driveshaft and needs to specify the measurements. Above all, the measurement of the estrus where the lock attaches. Does anyone have these measurements? Thanks !!!

Replaced floor, but did not take measurement for high beam switch. Can someone take a couple measurements.

Hello friends, I’m working on fitting some aftermarket front fenders (unknown brand) and they’re lining up pretty well. The problem is there were no holes drilled for mounting whatsoever. I’m reaching out to see if someone could give me a measurement on how far out the fender should be from...

How do you measure bent rims or axles? What would be a limit? Picture is of one wheel measured at the outside edge of the wheel. Still chasing a vibration at around 65mph Bearings are good, but will probably check em again. Also drive shafts are balanced. Thanks

Hi all, Currently stripping my HJ47 Ute back to it's frame and am checking it over for squareness. Pretty new to this and unfortunately the second frame I had which I was hoping to use has far too much internal rust to consider it so I'm trying to seek some advice on how bad the frame I have is...

Hi all, I'm chasing an idle issue and it might be idle air control (IAC) valve related. Mine wasn't moving, but I disassembled it, cleaned it, and it moves now. What I learned while cleaning it is that the length of the moving part is adjustable. I made a best guess at installation depth, but...

I've had EFS single-nut adjustable panhards on the 80 from way back. Today to temporarily sort out the punctured rear tyre issue while I get a repair kit I took two of the three Toyota factory 16 x 8 wheels with the 285/75-r16's off my box trailer (I only have three of them) with Chinese...