driveline

I have an 07 lx470 with 190k. 3-4 years ago upon purchase I had the driveline clunk which went away transiently (for about 500 miles) with lubrication and eventually went away with regular maintenance (every 5k miles) (had been neglected before my purchase). For the last few months+ I've been...

Should I use my regular grease (Redline CV-2) or should I use a “Red-n-tacky” grease from Lucas or similar? I’m getting that “clunk” when accelerating from a stop. Thanks.

I have a 1970 Fj40 that is in its final stages of an LS Swap, 5.3, 4l60e. The engine is already pushed 1 1/2" to the driver side to help with driveshaft clearance. The only issue is the front driveline is still extremely close (1/4"). I used the high flange kit from advanced adapters and had a...

Wanted to hop on here and see if anyone knew what could be going on with my 80. At approx 55 miles an hour while maintaining speed or coasting I feel a pretty violent lurch. Feels like it could be driveline related. My 80 is lifted 3 inches, no caster correction, but does have a front dc drive...

Hi All, Have one of those situations with multiple leads that could be acting as red herrings... Low mileage 1999 JDM 4.7 (130k kms). Never been less than perfect for me. Fairly recent fresh fully synth oil and NGK Iridium plugs. I live on a small Caribbean island so dealer and...

I know driveline vibrations have been talked about a number of times on here, but through my searches I’m having a hard time finding a situation similar to mine. I see most occur at driving speeds, whereas mine is exclusively at very low speeds, under 10 mph being the worst. I notice it most in...

I've been battling chronic driveline vibrations from the rear driveshaft on my LJ78 for the past couple of years. Initially my driveline angles were out of spec due to the engine swap, then I discovered that the driveline shop where I had the rear shaft shortened failed to properly balance the...

I've had my 97 LX450 for a little over a year now, and like many with lifted 80's, there's been an issue with driveline vibrations at highway speeds. It's not really a case of vibes on deceleration. The vibes start at 2800 RPM's and get worse as RPM's increase. The vibes get particularly bad...

Chasing driveline vibrations after doing a bit of work on my fj62.( This is an Aus vehicle. So 3f H55f combo). My rear driveshaft did end up getting seperated by accident. I put it back together in phase. But have had vibrations ever since and being my daily driver have had to drive it like...

Been hemorrhaging money on this old Landcruiser lately, what's a little more? Vehicle is a 1995 80 series with ~350k miles. Currently has ARB front bumper, ComeUp 9.5 winch, and MetalTech sliders. Rear bumper is stock, no cargo drawers or anything at the moment. As for me, I've been building...

Trying to find specifics for which diffs the 250 is carrying. I poked around google for a while and tried snooping for details in Youtube vids, but I've come up short (so many YT'ers missed getting detailed chassis shots that I'm guessing Toyota forbade their collection). Anyone found anything...

Hey all, sorry to bring up another one of these, but I feel like a moron riding around with this noise. Just started a day or two ago, with no recent maintenance done that would've affected it (I did replace window trim moulding finally, but doubt that messed up my driveline). As a starting...

Hello, located in western Washington. Looking for a front drive line for my modified Fj40. It has the 350 conversion. Looking for a front drive line that came out of a 350 converted Fj40. Mine is a78. So I believe a 75 and up would do. Thanks in advance.

1997 Lexus LX450... Yesterday, after heading back to Tucson from SW Colorado, climbing a hill, there was a loud crack and a bang, sounded like a rock came off the hill and hit a couple of things underneath (not an actual rock in this case), and following, I couldn't drive faster than 50-55, and...

Hi, I have a strange noise that only occurs on the freeway 50mph+ i have checked phasing and u-joints which appear to be fine. heres what happens and only with these conditions - i can be going flat at highway speeds foot on the accelerator and under load. in the seconds when i release my foot...

Pardon everyone for posting this on the Compiled Suspension spec thread earlier. I recently picked up a set of King 2.5 resi adjustable shocks for 0-2" lift for my 80 as well as 2.5" caster plates from Wits' End and new OEM bushings for the control arms. I'm on OME medium springs (~ 2.5" lift)...

I know there are topics explaining driveline chunks coming from the slip joint, but I'm convinced mine comes from the transfercase. I'm wondering if it could be the result of a sloppy transfercase chain. Mine has 210k miles. Does anyone know if the transfercase in the 100 series automatic is...