So I have a greaser mouse living under the hood. It’s little mouse paws are generously coated with engine oil, therefore rendering my glue traps ineffective. Any advisable methods of capturing this Slick Willie? I’ll be setting spring traps tonight, perhaps I’ll pick up a small electro shock...
Truck had around 355,200 when fuel filter was changed. Purchased from original owner around 345,000. Is it original? The acceleration is noticeably improved.
almost beast like 😂🤣😜 but not quite
Hello
I have a 97 fzj80 with rear heater , I’m about to replace the hoses under the body but want to make sure I have the correct hoses before removing the old hoses. I measured the 2 metal tubes coming down from the firewall and into the rear heater (near the cats) I measured near the fire wall...
Ok so I ran across this Abrasive Machining/Extruded Honing, was wondering if anyone has done this with an engine and what the results were. Given the 1fz has pretty lengthy intake ports along with a rough inner surface finish, I would imagine honing along with a good port job would really...
Hello,
I searched but couldn't find the answer.... 70 Series HZJ Manual Vr Auto Trans (non Turbo)
So im looking to get into a 70 series (2 door 2 row). If I lived in an area that wasn't subject to frequent traffic jams I would go for the manual version hands down. I have owned many manual trans...
22RET Bell housing will ship at buyers expense
$450 for the bell
Also have a Rad Designs tripple shifter setup for top shift t cases. $275 retails for $339 brand new in box this kit has the links
Hello
Looking to trade for a 100 series
97 with 350,000 miles. Toyota replaced head gasket at 260,000 miles (online service records)
I have replaced:
New 555 rod ends
New manafree HD drag links
Pesky heater hose and pipe
New harmonic balancer
33” geolander MT
PVC valve hoses, air intake tube...
Ok all,
So the fuel filter banjo bolt it’s rounded off. Fuel rail side (rear) any tips on removing this?
I’m thinking of removing the upper intake, removing the fuel rail banjo bolt, cutting the hard line from filter to fuel rail, installing new hard line. Anyone done this route or have a...
Hello
Currently Have IM 2” springs planning on adding 20mm spacers or putting in a pair of 3” springs. Totaling 2-3/4 or 3” lift
I have the Heavy Duty Man-A-Fre tie rod kit. Question is…. if I install the Landtank 2.5 caster plates will I have to grind some clearance in my stock Radius arms...
Does anyone have info on Bump it off-road aka BIO? Id really like to pick up a set of his step slider, a few months ago he posted he wasn’t taking order due to material shortages , now I get an error when I try to open his website.
Side note:
Id pull the trigger on some Slee or Delta sliders...
Hey guys
I’m going to pull my injectors. On my 1FZ with 350,000 to have them cleaned and flow matched I was wondering “since I’m in there” if I remove the upper and lower intake if it would be easy to replace the following:
Pesky Hester Hose (from the top down)
Fuel Filter
Have upper and...
Hello all
So I just replaced my distributor O-Ring -oil pump seal, front crank shaft seal, valve cover.
Is this oil ontop of my housing coming from my oil pump cover or somewhere up top?
Thanks
1997 1zfe
Hey guy I know this is popular topic that’s been widely discussed I’m running out of options
Methods I’ve attempted
- crank holding tool with 1/2” and 3/4” breaker
- Makita impact
- Milwaukee 2767-20 impact
- 2 bump starts then Milwaukee
Up next
~ crank holder with 2 3/4 breakers...
Looking for Quad Headlight part numbers,
Due to the unavailability of stock USA headlights, I’m looking to convert my NA 97 to quad headlights. I have a few possible contacts overseas, where I will hopefully procure the items necessary for the conversion
Headlight Housings
Headlight Trim...
Hello All
Anyone know what my spark plugs are trying to tell me? I’ve had 2 different opinions from to knowledgeable sources. One says to hot and the other says cheap gas
Removed from 1FZFE after purchasing from original owner. I didn’t see any tune up service records on Toyota database. I seen...