HJ45 in Oz (1 Viewer)

[The Punter]

Rotors and bearings done

 

[nogo]

Slotted & dimpled no less, very nice!......What master cylinder will you use, 47 disc brake type?

 

[The Punter]

Slotted & dimpled no less, very nice!......What master cylinder will you use, 47 disc brake type?

Not sure yet, I have the one out of 60, what's everyone else do?

 

[The Punter]

Last gift from the 60... lsd

 

[Ando27]

Are those 60 centres in a 47 housing?

 

[The Punter]

Are those 60 centres in a 47 housing?

That's the 60 housing

 

[nogo]

RE: Marks engine mount adaptors....Are these supplied at a predetermined length or do they need modifying for a individual vehicle (40 Series)?....And I notice the bolt holes in the adaptor legs & the actual engine mounts are slotted, is this to make fitting the motor initially easier then weld afterwards?

 

[The Punter]

RE: Marks engine mount adaptors....Are these supplied at a predetermined length or do they need modifying for a individual vehicle (40 Series)?....And I notice the bolt holes in the adaptor legs & the actual engine mounts are slotted, is this to make fitting the motor initially easier then weld afterwards?

The slots are to make the engine easier to fit, the brackets get supplied in two pieces and then you weld them together based on where you want your engine to sit. They are all the same I believe as the 40 front doesn't really change between chassis.

i can get closeups if you want a better look

 

[The Punter]

Tie rods tided up, de-bent, painted and new ends. Also cleaned up the locking hubs. Just calipers and pads and the front end is done!

 

[The Punter]

Last diff stripped. This makes 4.... I'm over diffs!

 

[The Punter]

Locking hubs completed and working, started on rear diff

 

[nogo]

Just let me know when you're finished your diffs and I'll drop mine off for a once over!

 

[The Punter]

Just let me know when you're finished your diffs and I'll drop mine off for a once over!

I'm all over diffs!!

 

[The Punter]

Onto the rear. Probably spent way too much time rescuing the 60 backing plates but I need the handbrake. They were pretty beaten up

 

[rolltide]

Hi mate great build looks like a good follow.
What you planning to do with the engine rod damage and gearbox setup? Cheers

 

[nogo]

Punter do you still have the original transfer case that was behind the H ?

 

[The Punter]

Punter do you still have the original transfer case that was behind the H ?

Yes

 

[The Punter]

Hi mate great build looks like a good follow.
What you planning to do with the engine rod damage and gearbox setup? Cheers

It's a 307 sbc, which I will swap out for a 350 crate motor right st the end as they are about 4 grand. You want the 307 for a reef?

 

[nogo]

Yes

I was just on gumtree looking at Landcruiser parts and thought that looks familiar!.... How ironic I should ask!
I am interested in the transfer case.

 

[The Punter]

I was just on gumtree looking at Landcruiser parts and thought that looks familiar!.... How ironic I should ask!
I am interested in the transfer case.

No worries, where in oz? I think I listed it for $150 just to shift it