dogdaysindurham's latest activity

"I mentioned a similar issue here. Likely, the cable came off the mount. Try locating the cable and pull hard." It is this (thanks borescope). Now I need to fashion a tool to get in there and hold the cable housing collar through a very tight...

P0420 doesn't necessarily mean a bad CAT: From FSM: Gas leakage on exhaust system Heated oxygen sensor Three−way catalytic converter Other issue can also be at play affecting one or more of above.

Those services have nothing to do with CAT DTC P0420 & P0430, by themselves. But there are common issues during those services, that may be contributors to CAT DTC. Prolonged idling. Vacuum lines left off, damaged or lose. Low coolant level in...

P0420 will not be set based on fuel trim. It would result in a P0171/P0172. See the link below for how to diagnose a P0420. Code setting criteria for a P0420/P0430: After engine and catalyst are warmed up, and while vehicle is driven within...

Also had to buy new nuts to secure the o2 sensor and those nuts are 8m 1.25

You can try 2 cans 44k in full tank. Sea-foam foger. Than Chevron techron, next tank. Yes even more CAT-a-clean (last best IMHO). But very unusual for a CAT, even more so for both to go bad on 98-05 even at 1 million miles. You must find and...

Red circle in below diagram. Passenger side, immediately behind the cat, on top of the pipe. EDIT: This diagram does not apply to 06-07 model years.

FRONT AND REAR ABS are on the website and available. 80 speedos should be available on the website in a day or two.

For you guys that are swapping in 80 axles and 80 tcases and using GPS speedos. 80 Tcase Speedo Block-Off Plugs 80 Front and Rear ABS Block-Off Plugs Jason TT

Holcomb Valley is burning, the Gold Fire, is currently at 30 acres. Reports have it located near 3n10, John Bull trail.

Can't see clearly in your picture, what is pipe/tube with open end? Nice job finding the leak. I've not heard of any known issues with the bypass. Coolant traveling down water pipe from heater hose T could do this, and would be easier fix then...

For sure your coolant system was over pressurizing. If you had you asked me to do a remote PPO inspection. I would have warn you, about concern with this engine over-heating. This is based on what little you've just now disclosed about history...

Old style, new style

If you replace your _____ every_____, you will greatly reduce your chances of getting stranded. Obviously, sometimes these parts fail sooner. YMMV. Heater T's 90k Alternator Fan Bracket Pulley Starter 150k Brake Booster assembly Radiator...

Before it starts screaming at you. https://forum.ih8mud.com/threads/poll-on-total-brake-failure-in-100-series.872498/

Honda sells rodent tape- https://www.hondapartsnow.com/genuine/honda~tape~rodent~19mm~20m~4019-2317.html Its tape infused with spicy capsicum to deter those bastards from causing expensive damage. It'll be a project, but worth it.

I just ordered a roof rack from Dissent. Anyone have one and use external molle panels on the rear windows. I am trying to figure out what ones are compatible with the Dissent roof rack. All I can find are Prospeed, which have two versions and...

Have you asked Prospeed? You may not be the first person to try this. Looking at the mounting system, it looks like it has some adjustability both up/down and left/right.

Contact Ben the owner at Dissent. He had that kind of setup on his orange 200 Series. I’m sure he has the files saved and can make you something similar. @benc

I would be down for the adapter. I have a set of external molle panel waiting to be mounted.

I'd be interested in a set if you need some quantity to get them made. Been wanting some for a while and was always hoping Dissent would finally release them.

Hello guys, Just posting this thread as we continue to improve the product line for the 100 series landcruiser. The comprehensive kit for the INTERIOR and EXTERIOR of the 100 series has been around for a while now. The kits are sold...

I'm looking at getting them custom made. Ill let you know how it turns out.

Depends on how corroded your studs are at the exhaust manifold. I had to replace a stud on each side due to impatience. I would highly recommend using MAP gas on each stud prior to removing the nut. Get them glowing red, it will save you a lot of...

Hi all, Posting my successful process of clearing my P0430 code on my 2003 LC. awhile back I would get the CE, VSC lights that would stay on for a bit then go away. About 6months ago they came on and stayed on. When I got my oil changed I had...