scrapdaddy

I think in the second video he shows the lap weld back where the joint is facing upward ( or downward?)so water would be hard to get to? I might be wrong about this as I was my third beer. 👍

Oohhh you be parking dis 1 in da livingroom😳😲🤔🧐😏😮😘.

My son and I scrubbed and scrubbed today. Just trying to get the Pig stye smell and grime out. We pulled the mats today, hit everything with a bucket/sponge bath of warm water and dawn dish soap and a good vacuuming. The front floor boards are...

Yeah, looks like the one on my parts pig.

more

ScheelMann custom seat brackets are made. These will go to powder next week.

Lap or butt weld ? This guy has a few thoughts.. Two years later he made this video.

Rush didn’t need no fancy new tape, his is perfectly good still Bob…

That's actually the moody pig... You can tell by the tank top...🐖👈

Sat through the border line today, no drama at least. I still need to order way more parts for the fall push, but this was today’s progress.

Pump arrived today, early and in good shape. I emailed the mail service in Blaine stating the package had my last name misspelled and after lunch I got the reply it was there, so a nice win on our BC Day Holiday up here. :beer:

It's a terrible thing!

Stretchy nuts......

Why Ron playing Pocket Pool 😳😮🍺😘😏😲🤣🤣🤣🤣

2022

What’s cooking?🧑‍🍳

https://www.amazon.com/Kittmip-Extension-Undercoating-Flexible-Vehicles/dp/B0CLL5GRKN

I could of used those extensions when I did it all.

Some of the stuff I've used recently. I'll spray something on the rust first.. Then I'll spray a coating like POR-15 or any of the rust converting/directly on rust type coatings or a two part epoxy marine type primer with a pressure pot and an...

We get another, another 90 days for before it isnt cheap.

Ya know he not a welder 😏😳😮😲🤣🤣🤣. Get grounded OUT ⚡️⚡️🔥

Why indeed.

I haven’t done a metal working job without this since I bought it. Usually I hit spotwelds with cutters. I’ve seen them done with the belt sanders. The belt sanders are supposed to be a lot faster getting things apart, but don’t know how well...