Inukshuk

Great! CB Mtn Biking is amazing and leaves will be peaking

I'm still using that master cylinder regularly. It's going to slow me down in Crested Butte next week

How are the seals holding up after 4 years? I just took apart, cleaned, and reassembled the same lever on a new-to-me used bike. All parts looked great so I am hoping transient debris caused the leak. Next step would be these aftermarket seals.

Cylinder scoring? What cylinder scoring? Cross fingers your cylinder doesn't look like this: If it does, well, you're still probably going to get another year or two out of a bad ass lever. If it looks better than that, then you've got a...

The dual AUXBEAM 3” foglight housing for LC100 Prototyping

M19V6 LC100 Dual Baja Squadron Housing Status: Prototyping completed Testing in progress

To compare

E-mailed ya!

Dual Baja Designs Squadron in LC100 foglight pocket Still in design phase

Looking for Volunteers! Currently designing a dual Baja Designs Squadron light mount for the LC100 — anyone interested in helping out or testing?

Glad to hear it! Like other M19 series products, it is $150/pair plus shipping.

Make 19 V5: Baja Designs Squadron and S2 Mount for Toyota Land Cruiser 100 Series

Tighten disengaged. Crank adjustment until it completely stops all motion. Back off 2-3 clicks. Job done.

ok, I'm sure everyone needs a good laugh today so at my expense here goes.... I have spent a lot of time tracing out this suspension system issue and I am not a beginner at troubleshooting systems by any means, however I am standing before you...

Analog vehicle mounted cell phone antenna mounting point.

The left rear pane is fixed in all LX450s regardless of mobile phone installations.

My engine was making a ticking noise and I had initially chalked it up to a leaking exhaust manifold. Upon reading this thread I checked my plugs and found all were super loose, not finger loose but well below the specified 17.5nm for sure; the...

I reached out to a seller on Etsy for a custom order. He built a set of custom recovery points that I plan on welding through the ARB bumper. 3/4" thick, chamfered hole for soft shackles, and custom length...

more than 15 years later, this OP is still paying it forward! Broke my wire off doing the PHH and fixed it so much more easily because of your post!

You use a thread back tap, like this one. It's able to be inserted into the hole, then you expand the threads and run it back out slowly. It cleans the threads and brings any debris with. I have used one for soot caked glow plug threads on VW TDIs.

We are happy to hear from you and hope you are enjoying your sliders. Stay tuned for all the good things that are coming.

Yes, operations are still in northern CO.

Hello Friends! We are excited to announce that Bump It Offroad is back! For a minute it looked like Bump It Offroad was going away. The folks at TriMeki (@Fe3 ) had a better idea, and now Bump It Offroad (BIO) is a TriMeki company. Bump It...