Has anyone made 2 piece doors that fit a factory soft top? I am curious because I would like to not have to run hard doors all the time with my FST. I like the visibility that the aftermarket style 2 piece doors afford when wheeling.
Two piece doors for Factory Soft Top?
- Thread starter Stumpalama
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Cdaniel
Undocumented Mechanic-I Am Not CDAN
Not an FST, but the idea is the same
http://zot-art.com/cruiser page/Half Doors.htm
http://zot-art.com/cruiser page/Half Doors.htm
- Thread starter
- #3
Right on! Thanks! I'm pretty sure I stole his solid 1/2 door design. It's been so long, I forgot about the top of the door.
like this? from pakistan (ehsan)
Here's more of the Paki doors. Don't get excited, you can't buy them.
If you have those, you should have these too...
If you have those, you should have these too...
those are mine pre-shipment! .....maybe
- Thread starter
- #7
Thanks for the replies. I had seen those Pak doors as well, but couldn't find anymore information on them. Looks like I have a winter project.
myquestoyota
SILVER Star
I liked the ones I saw on here somewhere that had the older wing window style doors with the top portion removable. I never liked how low my half doors were. I just had some metal plate for doors but if I did it again they would be high enough to rest my arm on. Anxious to see how you approach it.
- Thread starter
- #9
I am running plate 1/2 doors as well right now. They are cut to fit my STC top. This will give me the opportunity to finish out the doors a bit, adding some interior finishing and an arm rest like myquest mentioned.
I did see that other door, I think. Did it look like an FST door on the bottom but divided on a slant?
Fortunately, I'm near one of the largest sailing cities and there is no shortage of boat fitters and upholsterers.
I did see that other door, I think. Did it look like an FST door on the bottom but divided on a slant?
Fortunately, I'm near one of the largest sailing cities and there is no shortage of boat fitters and upholsterers.
Here's a great idea for a set of split canvas doors that could easily be used to work with full steel doors on the bottom.
Split canvas doors
Split canvas doors
- Thread starter
- #11
Yep, that's them... Funny, I searched Google and 'mud and couldn't find more than on picture let alone a whole thread.
Last edited:
