RDC76
Fabricator.
I post mostly in the 80/60 section. but thought id share a recent build I just finished on a rear bumper and sliders...
The rear bumper is comprised of 5x2x3/16 wall structural tube with gusseted 10 gauge wings and 3/4'' thick recovery points penetrating both walls of the tubing. A very strong and light package at 85lbs..
the customer wanted something light, strong and clean...
anyways I just thought id share over here..
thanks
Rich
The rear bumper is comprised of 5x2x3/16 wall structural tube with gusseted 10 gauge wings and 3/4'' thick recovery points penetrating both walls of the tubing. A very strong and light package at 85lbs..
the customer wanted something light, strong and clean...
anyways I just thought id share over here..
thanks
Rich
Last edited: