Will 1" wheel spacers clear the lug studs on an 80?

[Razorbackcruiser]

Will 1 inch wheel spacers clear the lug studs so the rim will fit flush with the spacer. I just put on 1.5 inch spacers and don't like them (will be in the classifieds soon). The stance is just too wide for 35's, but I think 1 inch will be perfect but am worried the lug studs are too long.

I've searched and read some are running them but I also read where somebody trimmed the studs so they would fit. Just wanted to know if someone could give me a definitive answer.

Thanks in advance.

 

[Schwein]

I went with 1.5's because of people telling 1 inch would not fit.. However the studs are the only part holding back a narrower spacer so i imagine you could trim them back a bit, they are only metal after all.

 

[sleeoffroad]

On a 1" the stud will stick out slightly. On some wheels this is not an issue since there is a "cavity" on the mounting flange of the wheel. Stock wheels are like that. However if that does not exist you have to grind them flush or get 1.25" spacers.

 

[Razorbackcruiser]

That makes sense, thanks a lot Christo.

 

[80BajaBound]

I have 1" spacers and stock wheels. Make sure those wheels are balanced or you will get a wobble at higher speeds.

 

[akarilo]

The amount you have to trim in nominal, and a non threaded tip at that, (on mine anyway). 1 cut off wheel, 15 minutes, and you're done. As Christo stated, with stock wheels it doesent matter anyway; wish I would have noticed that first

 

[TRDCRUISER95]

I have 1" wheels spacers they fit perfect