I tried to cut my fenders last night. Things were going well after tig welding up the holes on my roof where my roof rack was....I didn't even have to take out my headliner. Next were my fenders. I was going to give them a good 3 inch trim and was prepared to do the fab work to the inner well area. Everything is ready, so go to take the fender off. Unbolt all the bolts on top and bottom, open the door and get that bolt too. Shortly I realize that the corner turn signal is going to have to come out. I take off the grill and start to try to take out the headlight to get to the turn signal. Take 3 bolts off and realize that there is a bolt holding it on that very well may be impossible to get to and unbolt. I think to myself, hmmm, there must be an easier way to do this. I end up turning every bolt and screw I can get my hands on and still nothing. I literally spent about an hour trying to get the headlight or corner turn signal out so I get my fender off.
How, on gods green earth, do you get these out?
How, on gods green earth, do you get these out?