Final pictures - no, not final - pictures of the cage install. I have a 24v powered AC compressor that I'm installing when it arrives.... but for now, this is it (the AC compressor is going under the rear passenger seat)
the cage is dividable and holds 2 - 100 plus pound dogs. Last cage, I used lighter-duty glides, not this time, those are 400 lb glides....
doors open with the divider in place
control panel for the electrics, above it is the input for the solar panel on the roof
2 water sources, the bumper and the bottle on the back - getting that fitting to glue to the bottle was a challenge
the seat (that will have the ac under it) - it folds to allow the door to be open to the cage and allow that pooch free range
other side, on the bottom is a space for a rescue pack and wet things, then two drawers (which are getting dividers), to the right of those drawers is the space for radios and changers, on top, medical bags
all the rear windows have expanded metal over the windows so that there's plenty of fresh air when stopped... also the foxwing awning covers the side and rear of the car.
front has HAM radio, and various light controls for the outside of the vehicle. Inside lights are controlled by the panel above
and there is the tour.... from here out, it will get a few refinements (such as better latches for the rear drawers).... but the only real change I'm making is I'll add another battery for 12v stuff and parallel the batteries under the floor so they can run the new a/c unit.