Rocker Panel /Rear Sill Replacement parts

[mudnyreye]

I am replacing the rocker panels and rear sill on a '73 40. Who has the best quality and price for these parts?

 

[addicted56]

Your local Steel supplier or machine shop.

A 2.5" x 2" piece of stock for the sill and any s...c...r.....a....p (it thought I was typing a bad word) they have to cut out and replace your rockers.

Price probably free to 20 bucks. probably 16 gauge on the rockers. Any wall will work on the sill.

 

[Trollhole]

I am replacing the rocker panels and rear sill on a '73 40. Who has the best quality and price for these parts?

CCOT has the best quality I have seen.

 

[Jakes40]

whant it done right do it your self.
I used 16 ga. book shelved for my rockers and 2 inch square stock for my sill.

good luck,
chris

 

[Coolerman]

Do it yourself and save big bucks. I spent a total of $230 for sheet metal at my local metal bender. I have two quarter panels, a new center channel, new rocker panels, a new sill, a new drivers side floor, and a new cargo floor. They cut and bent the metal to my specs and I welded them in.

The only part I bought was the wheel well tops from Real Steel, and they were junk. Unless they have upped there quality control don't get anything from them. CCOT does make good stuff.

 

[fieldsken1]

hi there i am replacing my quarters and rear sil got parts from real steel cruiser parts same as ccot i was there they said they would call me and did not so i went with them cheaper real steel cost was about 200 pre formed