I have posted before about my suspension regarding roll, lean and I still am baffled.
I have the OME stock suspension replacement:
Dated: 7/03
861 L/H ------front left
861 R/H ------front right
Dated: 6/03
862 L/H -------- rear left
862 R/H -------- rear right
=================
I mean going over a bump on an angle faster than .5 mph will through you side to side instead of SUPPRESSING the shock! Also, when I look at the springs, the majority of the spring is compressed and not "open". I would say 2/3 to 3/4 of the spring is compressed. So are these springs too soft?
WAY too much rock and roll! this set up is only 2 years old. They don't have stiffer springs and shock setups for the smallest height.
So, did I screw up buying OME? I paid a good bit of money so I would like to think that I don't need to put ranchero shocks or anything else on there too replace because I trust this board and I thought OME systems were specifically for LCs.
Bad experience guys......Are OME warranteed?
I have the OME stock suspension replacement:
Dated: 7/03
861 L/H ------front left
861 R/H ------front right
Dated: 6/03
862 L/H -------- rear left
862 R/H -------- rear right
=================
I mean going over a bump on an angle faster than .5 mph will through you side to side instead of SUPPRESSING the shock! Also, when I look at the springs, the majority of the spring is compressed and not "open". I would say 2/3 to 3/4 of the spring is compressed. So are these springs too soft?
WAY too much rock and roll! this set up is only 2 years old. They don't have stiffer springs and shock setups for the smallest height.
So, did I screw up buying OME? I paid a good bit of money so I would like to think that I don't need to put ranchero shocks or anything else on there too replace because I trust this board and I thought OME systems were specifically for LCs.
Bad experience guys......Are OME warranteed?