POPO AGIE
SILVER Star
- Thread starter
- #121
Started the bearing on the output end of the shaft onto the shaft and the case, then installed the input shaft. Seated the output end bearing against the snap ring and the case and the put the rear bearing cover/adapter plate to hold the shaft and bearing and hot bolted. Then started input shaft and bearing in the input end of the case and lined up the shafts so that the internal needle bearings road up onto the output shaft journal. Then seated the input shaft bearing in the case. I removed the rear bearing cover and installed the front bearing cover and tapped the output bearing and shaft forward to finish seating.
Checked the rotation with the reverse idler gear out of mesh as the bearings were seated.
Rear bearing cover on for seating the input shaft
Rear bearing cover removed again
Front bearing cover removed and bearings seated
Checked the rotation with the reverse idler gear out of mesh as the bearings were seated.
Rear bearing cover on for seating the input shaft
Rear bearing cover removed again
Front bearing cover removed and bearings seated