Hi All,
In the middle of my clutch install and wanted to replace the transmission input shaft seal and gasket. Got the old seal out and am
questioning if it was installed correctly reviosuly. the FSM does not show a good pic and neither does haynes. Also any suggestions on how to install with home tool Thinking about a 1.25" socket right now.
First pic shows how it was installed when I removed the old one.
is this the correct orientation or should it be flipped like the 2nd pic shows?
Thanks in advance.
Brad
In the middle of my clutch install and wanted to replace the transmission input shaft seal and gasket. Got the old seal out and am
questioning if it was installed correctly reviosuly. the FSM does not show a good pic and neither does haynes. Also any suggestions on how to install with home tool Thinking about a 1.25" socket right now.
First pic shows how it was installed when I removed the old one.
is this the correct orientation or should it be flipped like the 2nd pic shows?
Thanks in advance.
Brad