Hey there so I have a build thread in the pig preservation society page About my FJ55 that I’m doing an LS swap on. I was at a crossroads at the point of attaching the transmission to the LS swap bellhousing when I stumbled upon a Ranger overdrive in another FJ55 which I purchased. My question is since I have the new advance adapters bell housing LS/LC trans, Should I go ahead and run the other trucks small block Chevy bellhousing? I just don’t know if the Ranger bolt pattern to the bell housing would be the same between the two adapter bellhousing’s? Does that make sense? I want to make sure to use the best bell housing that I can.Has anyone adapted a Ranger overdrive to it Advance adapters more modern LS bellhousing?