maxamillion2345
Franken-80
I'd guess you're running 2.5s booger?
Doesn't look like those towers would fit 2.5s.
Doesn't look like those towers would fit 2.5s.
Random 3 link nonsense...
- Thread starter Booger weldz
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #62
Yeah 2.5 max, if they don't fit I'm selling the truck to they junkyard! J/K they've already been on it at full bump and droop(I have fake coilovers made w tubing and potato gun barrels for mockup and welding).
I'm guessing photos are deceiving cause when I look at sorenjins towers I imagine they'd rub bad on droop to the rear edge of the tower
I'm guessing photos are deceiving cause when I look at sorenjins towers I imagine they'd rub bad on droop to the rear edge of the tower
Last edited:
- Thread starter
- #63
Actually Brian sells his kits in many morphs. The front is minitruck for a diamond since I have 3.5" tubing. The rear axle has 4wu one ton parts on it.
- Thread starter
- #64
that cross member/skid is nice... i need something like that...
I didn't actually gain any major clearance with it. It's 1.5 .250 tubing with the tranny/Tcase raised about an inch. But I rubbed my tacos auto pan on rocks so the skid plate stuff was insurance.
Everything's about the equivalent of our gas tanks which seem to ride about an inch below the frame rail?
And the Madness Spreads through the forum!
Keep us updated.
Keep us updated.
- Thread starter
- #67
My exwife said I can have my garage back if I take her to the rubiconIt'd only make sense that they parked the short bus in your driveway.
View attachment 924059
Maybe you oughta hang out your own shingle..
- Thread starter
- #69
I was on it but Facebook crashed
think of bleach blond stick figure w atitude. EDIT: there's the ole gal !!She only contacted me cause she saw the 'new' 80 parked at my work and couldn't wait to smell my camping BO!
You mean your axle width inquiry?
Last edited:
- Thread starter
- #70
Damn this is turning out nice! That's about the same idea I had for the TC crossmember without the fancy couplings. Where did you get em?
- Thread starter
- #72
Kick ass... This is going to help, my rig goes under the knife tomorrow night... A few goodies of RS going on... They are great guys over there, helps that they are just down the street!
-A
Thanks! I started milking that 20% off yesterday and this beats the flange design I was going to go with.
- Thread starter
- #75
Yeah sometimes I go in person w cash and.... No shipping, no receipt wanted, etc...
- Thread starter
- #76
If you line them all up right it all drops with the bolts. You can undo two and then insert way long bolts. Then drop the tranny down a few inches(but still held) for access to the Tcase top or rear? I guess this works fine with the stocker too...
- Thread starter
- #77
When I grow up I wanna be able to fab metal and pick up geriatric hookers like you.
EDIT: Pick up geriatric hookers in the same manner you do, not calling you a geriatric hooker. Strange order of words there
EDIT: Pick up geriatric hookers in the same manner you do, not calling you a geriatric hooker. Strange order of words there
- Thread starter
- #79
Lol! I wanna drive this gawker in the swimmin pool and find somebody who can underwater weld and wants to cool off! 102 and counting.... Barf
- Thread starter
- #80
