Took the Rig out today for its first trail ride now that Uwharrie Nat'l Forest is open for the season. Ran into a problem though. Got about 1/4 down the trail to the first rocky challenging part and went after it. 4wd is not working. I am relatively unfamiliar with the 62 set up. Tried everything we could, bagged the day and came home.
1-hubs were locked
2-button pushed in and 4wd light was on
3-tried both 2 and 4 lo
4-Driveshaft spinning but front tires will not engage?
5-Could hear a clicking noise but just wasnt catching.
6-not sure if this was part of it but brakes became almost non functioning while i 4wd was supposedly on. they were ok again once it was off.
did a "mud search" found where solenoids, vaccum leaks, and a diaphragm all could be the culprits!? Where to start?
can anyone help?
1-hubs were locked
2-button pushed in and 4wd light was on
3-tried both 2 and 4 lo
4-Driveshaft spinning but front tires will not engage?
5-Could hear a clicking noise but just wasnt catching.
6-not sure if this was part of it but brakes became almost non functioning while i 4wd was supposedly on. they were ok again once it was off.
did a "mud search" found where solenoids, vaccum leaks, and a diaphragm all could be the culprits!? Where to start?
can anyone help?