What did y’all do with the fuel filler tube? Hammer it? Can it be easily moved back without hammering?
Official 40" and Up Picture Thread
- Thread starter PKP80
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I didn't do anything to mine. It has just barely rubbed the paint off. That was when I was at 3.5" backspace. Now I'm at 2.5" backspace and I suspect it rubs even less now. How much bump extension did you end up with? I'd put that fuel filler problem pretty far down on the list of stuff to do though.
Last edited:
nukegoat
Should have bought a Jeep
Moved it back
nukegoat
Should have bought a Jeep
That scrub radius must suck
Should have gone 42’s!
40’s are the new 37’s
40’s are the new 37’s
Lol shush ur face.Should have gone 42’s!
40’s are the new 37’s
How did you move it back? There’s a nice pocket for it to tuck into but do I just beat it with a hammer? Lol
I’m at 3-3.5 bump extension right now. Seems to be close but may need another 1/2” or so. I haven’t gotten that far yet. I’m still clearancing everything
nukegoat
Should have bought a Jeep
I cut and moved it
Ya that’s what I’m thinking. Cut it and use a hose to attach the section I cut out.
How much bump stop extension did y’all end up with in the rear?
What do you even mean lol
Last edited:
I’m at 2.75” with a 1in BL
Oh yeah. Forgot you had a BL. so ya I’m right at 3.5 I believe. I think I’m going to need 4”
My 97 . 4ds...
My garage has never looked so good. I'm spoiled...my 37s look so tiny now.
Ok. Last question. Lol
My passenger side tire is rubbing the exhaust when I turn to the right all the way. Did y’all cut and move the exhaust or just lift the front higher?
My passenger side tire is rubbing the exhaust when I turn to the right all the way. Did y’all cut and move the exhaust or just lift the front higher?
Made the tires shiny for a few pics.
Let it rub and dont turn so sharp.
Seriously though, that's what i was told when i asked about this to a friend running 4Ds.Lol ummmm. I’ll just do to it what I’m doing to everything else. Take a sledge hammer to it.Let it rub and dont turn so sharp.
