I'll make it short and to the point. Is there a no cut/no splice solution to tie in to the trailer harness so I can use this to power additional turn indicators and brake lights while still allowing the harness to function as normal when I tow?
Looking to tap in to the trailer harness
- Thread starter GrizzlyClint
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Bang Bang
Age is a state of mind.
Never seen a harness adapter like that. Have you tried etrailer?
- Thread starter
- #3
Wasn't aware of that site. I'll check it out.
Side note... for those that did lane change auto flasher that removes the trailer brake circuit IIRC
You can get a piggy back connection that is called a 4 way flat y splitter. It basically creates two 4way connections, one of which you can cut off and wire up as you like while still maintaining your original. Got mine from Amazon.
- Thread starter
- #7
That's one thing I'm going to test. I'll build a secondary harness to reconnect just those pins (+pwr&gnd) to the factory flasher to see if that works.
