Local For Sale/Wanted Section! (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

FJ40 for sale

I got a call from a lady wanting to sell her early 70's FJ40 I believe it was a 1972.

She wanted to fix it up and has done a few things to it from what she told me. It was run last in Oct and is located near Lebanon some where.

She was looking to get $4,000 for it.

Too much for me but if you are interested contact me and I can put you in touch with her!.

Craig
 
I'm looking for a head for a 74 F engine. Mine overheated and cracked and would like to find one local if possible.

Thanks
Kevin
 
looking for a set of rear either 60 or 62 springs really only need the main spring( the long one) cause i can rebuild a pack. let me know if anyone has one laying around


thanks all


Bryon
 
I think I have a complete set that you could have.
I will look if they are still laying around.

Craig
 
I have 3, one was broken when I removed them and must have tossed it.

2 are smaller spring packs and 1 larger spring pack. I don't remember which are the front and which are the rear.

If front and back are the same length the main leaf would work.

If you want them you can have them.
 
Hardtop Door Header Trim

I'm looking for a mate (other side) to the trim piece below to replace more parts my painter lost. This is the angled trim piece that goes above the front doors on a 40/45.
IMGP0729.webp
IMGP0730.webp
IMGP0731.webp
 
Last edited:
Need room in the garage.

I've got 2 good pre 74 Windshield frames with good glass slight surface rust on 1 and they other has fresh orange paint. $200 / 350. Front and rear axles out of a 78' so front discs 300 for the pair. Hard doors from a 78 in good condition little to no rust $250. Other random stuff laying around a few hoods. Let me know what you need really need to make some room for the new project.

Thanks,
Dan
610-360-9549
 
i have a Leer fiberglass topper / truck cap for sale. Fits a 1995 or newer Tacoma, but also the 1989-1995 models as well (just curvier to match the newer cabs). even fit on my roommate's 1996 Ranger, just a bit narrow at the cab end.

cap is in very good condition, both side windows slide / have screens, and back hinges/pistons work great. windows are tinted, and the cap is a dark green color. Will need new seals/weather stripping I think. it was replaced with newer stripping but not that thick, so I leave that up to you.

I got it for my fathers 1997 Tacoma (red) but after I picked it up he decided he didtt' want it anymore.

located in Elizabethtown, PA, and needs to go as I don't have any vehicle I can transport it with and I am moving at the end of the month.

*edit*

needs to go. first $150 takes it.

call me 570 76five 22four6 or email k.bbmarch (at) gmail (dot) com
 
Last edited:
Anybody have a running 2f and 4sp trans for sale?
I have a 4 speed tranny and transfer case sitting in
my shop that I want to get rid of. Make me an offer if interested.
 
anybody have a need for a 1970 3spd tranny/transfer?


how about some mid 80s pick up doors or 4:88 rears for the same?...along with the axles and housings. and a few other parts as well from an '86.

have two NOS goodyear st225/75 r15 trailer only tires as well.
 
anybody have a need for a 1970 3spd tranny/transfer?


how about some mid 80s pick up doors or 4:88 rears for the same?...along with the axles and housings. and a few other parts as well from an '86.

have two NOS goodyear st225/75 r15 trailer only tires as well.

Do you have the cab from the 86 still? I need a roof section to weld back onto my 88 4Runner since I rolled it. If so, what do you want for it?
 
what load range are they? any dryrot/weatherchecking? very interested. ;)

i don't know off hand, but can find out.
they have been stored indoors so they should be fine, but will check that also.
 

Users who are viewing this thread

Back
Top Bottom