Local For Sale/Wanted Section!

[zucruisers]

hey guys, i have a bunch of random small parts left over from the 40 i got awhile ago, i tried selling it all, but with being in school full time it leaves very little time to pack and ship parts and everyone of the buyers backing out or not getting back to me, i ended up not selling a single thing, if anyone wants anything, check out what i have listed here -

https://forum.ih8mud.com/showthread.php?t=127809

if you want something, and you're going to be at the next meeting or cmcc, ill send it along with jeff if i wont be there, the prices listed in the for sale thread don't matter, just give me whatever you think its worth and im ok with that, i just need to get rid of this stuff and i dont want to throw it away if someone can use it

 

[jtaco1]

**'95 4runner with 3.4L engine swap**

$6000 OBO

Located in Lancaster, PA

My wife is 3 months pregnant, and I have made a deal with her to let me finish my FJ40 before the baby comes - but unfortunately it includes selling my 4runner.

She will let me finish the 40, but I need to buy a beater car to drive and sell the 4runner to pay for the cost of the 40 completion!

Picture Gallery -
http://www.andrewzook.com/gallery/v/trucks/95_4runner/

Swap details -
http://www.andrewzook.com/index.php?option=com_content&task=view&id=22&Itemid=48

Truck
1995 Toyota 4runner
Red with grey interior
Power locks/windows
Power sunroof
Power mirrors
9000 miles since 3.4L V6 engine conversion. Engine had 70k when installed.
Stock 5 speed transmission with new Toyota clutch/pilot bearing/TO bearing
2" body lift for engine clearance
3rd generation 4runner wheels
ADD disabled - locking hubs installed
33" tires
New rotors/calipers/pads/wheel bearings on 5/07
Timing belt / water pump 5/07
New relay rod/tie rods/tie rod ends replaced under warranty 6/07
All factory gages work with engine swap, cruise works, ODBII works
No rust
Beautiful condition
Clean interior
19 mpg highway

I have to finish the AC setup - but it will work when sold.

Only 5 wires in this entire swap were spliced. The remainder of the wiring was removing pins from old plugs and clipping them into new locations in new plugs.

Very reliable - as reliable as the 70K mile Tacoma that the engine came from. Does not use a drop of oil, would not hesitate to drive anywhere.

Thanks!
CAZ

Andrew,

Sent you a PM about your truck, very interested. Would like to come see it and see what we could work out.

Thanks

 

[zucruisers]

hey guys i have 4 goodyear mtr's, 35x12.5 15, i was told they have about 2000 miles on them, 2 or 3 of them have some rock rash on the lugs, one is almost brand new and only has 100 miles or so on it, all of the center lugs are custom grooved, right now they're on wheels, which arent included and are not for sale,
i also have one goodyear mt thats about half tread for a spare that will go with these, $700, located in northumberland, pa 17857, i can help with delivery for the cost of fuel

http://www.zuwharrie.com/gallery/albums/userpics/13632/IMG_2082.jpg
http://www.zuwharrie.com/gallery/albums/userpics/13632/IMG_2088.jpg
http://www.zuwharrie.com/gallery/albums/userpics/13632/IMG_2085.jpg
i can get some better pictures if needed, the 4th mtr that isnt pictured is the one thats almost brand new, and i think all the miles on these were under a cj, just fyi

 

[jtaco1]

Wana trade for these plus some cash?? 285/75/16 around half tread.

Tires
http://i2.photobucket.com/albums/y4/jtgraup/_043.jpg
http://i2.photobucket.com/albums/y4/jtgraup/_042.jpg
http://i2.photobucket.com/albums/y4/jtgraup/_041.jpg
http://i2.photobucket.com/albums/y4/jtgraup/_040.jpg
Spare
http://i2.photobucket.com/albums/y4/jtgraup/_048.jpg

 

[zucruisers]

sorry i cant trade on these, i found another set of tires i want to buy, so i need the $$ so i can afford them

 

[jtaco1]

Gotcha, good luck.

 

[Wayneraintree]

good enough deal to post

http://www.rc4x4.org/rcforum/index.php?topic=79.0

 

[Wayneraintree]

Gary S has this for sale for 1500$

High mileage, runs good, A/C blows cold...... be a great foundation for a trail rig or driver

 

[76FJ40]

Braided Stainless Rear Disc Brake Lines

I bought these for my rear disc conversion and then realized they wouldn't work with my 3 link. These are new from TSM; the passenger's side is 14" and the driver's side is 44" as I recall so the lines go from the T to the caliper. The lines are metric on the T end and banjo on the caliper end to fit thr Monte Carlo calipers. $45 shipped or $40 delivered to CMCC.

 

[Straydog]

I got a little happy with the welding. Anyone got a computer for sale(or that I can borrow). I think I burned mine up. Long story. Poor ending. But my 4runner won't run and I think thats why. 87 22re.

 

[Wayneraintree]

email Gary...

 

[shmukster]

81 Toyota truck front and rear axles cheap

Selling a pair of axles removed from an 81 Toyota truck odometer read something like 102K miles. Axles look to be in good shape. Front axle complete with steering linkage, tie rods, stabilizer, and is complete from Aisin hub to Aisin hub. $125

rear alxe has emergency brake cable and is complete from drum to drum prioce $50. Buy both axles for $150. Or buy both axles minus the Aisin hubs for $1000. actually there are two original 81 truck wheels with tires on each axle in their original white color. They go with the axles.

I'm in Brockton PA not far from either Paragon or Rausch Creek.a Many of you guys have been to my place already. Somebody please come and get these axles out of my garage!!!!!!! Shmukster email smukter@pa.metrocast.net or here at work GSCHMAUCH@cartech.com

 

[shmukster]

Free Toyota wheels and tires

I have several Toyota factory wheels here that I'd like to give away. All have tires that are at least decent. Some of the tires are quite good. I have one complete set of four or five chrome 60 wheels and have several others like them. Have several stock plain steel wheels, too. Any or all available to whoever gets to Brockton to pick them up. At the very worst they are good rollers at best they have plenty of tread and are inspectable in Pennsylvania. No shipping, don't ask. Email shmukter@pa.metrocast.net or here at work GSCHMAUCH@cartech.com.

 

[shmukster]

Axles have been sold

Sold the rear axle to John Embrey Thursday after he broke his at the CMCC. Sean is buying the front axle. Thanks for your interest. Gary S

 

[Wayneraintree]

Red extra cab mini 600$

https://forum.ih8mud.com/showthread.php?t=166357

 

[bsacavag]

OK, someone sent me a request about the drum brakes I was giving away but when I tried to open the link, it crashed and I can't seem to find it again. Anyone interested in these parts please let me know.

Bruce

 

[crawlin40]

Parts in Kutztown, PA

40 and mini parts E. Pennsylvania, P/U Only

--------------------------------------------------------------------------------

Come get this stuff, make an offer on anything, or take it ALL for $400 FIRM and Ebay what you do not want. Here is the list.
1985 Mini front axle (this year has extra gusset, does not matter if you are using it for a LC but could maybe sell the housing after getting the DB stuff off of it) with 3rd member Aisin Hubs$200
Jumpseats, late model with support leg/kick out $200, missing straps
'74 spd xfer case with all linkage & handle $100
vac shift xfer cases (2) one with 3 spd tranny $30 for all
(5) 3 speed ujoints to mate 3 speed xfer case to 4 speed DS, put these ends on your 4 speed DS and mate that lower case your facory 4 speed, buy a non US tranny for $500 and get even lower gears all Toyota and on the cheap, all 5 for $50
'74 fj40? distributor $20
Confer extetended shackles 1 pair $20
IFS ps steering box from 86-95 Mini/$runner $50
1 warn coarse spline lock out hub $20
stick shift to convert 3spd column to floor shifter including wiring $30
2 chrome fj60 wheels with usable stock size tires $20
Factory jack with bag and all handles, hubcap spoon $20
PLEASE use this email for fastest response as I go on Mud 1-2 times a week: crawlin40@hotmail.com
Thanks
Misc. small parts you can have also, nothing special but HELP ME CLEAN MY GARAGE!
pick up only use zip of 19530 to map it
Kutztown, PA Matt Reed TLCA#12322

 

[Wayneraintree]

https://forum.ih8mud.com/showthread.php?t=168620

FJ60 4.56 thirds with Auburn LSD

 

[zucruisers]

i have 2 engines in my shop that need to go

1st one is a 22r, out of an 82 minitruck, the odometer said 186k when i pulled it, and it ran pretty good before i pulled it out, the carb, intake, and most of the accessories are on it as far as i know, the exhaust manifold is gone and the oil pan is rusty because i needed the good one that was on it, when i had the pan off there was no gunk, metal shavings, or anything unusual in the bottom end

-i'd like to get $200 out of it, if anyones interested i can get pictures of it and more details

2nd one is an f engine from a 72 fj40, the odometer said 91k, which i think is original mileage because the last inspection sticker on the truck was from 1981 or so, i dont know if it runs as there was a mudwasp nest in the carb, i can check and make sure it turns over and isnt locked up, the bellhousing, clutch, starter, and dist are all there, the manifolds and carb are removed, but i have them

-$150 complete, $100 without the manifolds/carb

these are pickup only, or delivery might be able to be worked out for the cost of fuel depending on where it is to, but right now they're both in my shop, in northumberland, pa 17857

 

[Wayneraintree]

I need the carb...