- Thread starter
- #81
So I think im gonna try and cut this nut off, but I’d like to avoid using a hack saw.
cheap rotary tool with a cutting wheel should work, yeah? Angle grinder and cutting wheel seems a little large for the small space.
either way figure the steps are
- Cut the 4 welds holding the nut to LCA
- Smooth out surface where welds were
- Drill out hole to fit rivnut
- Install rivnut
- Business as usual when bolting in the sway bar bracket
seem right? Would I get better hold strength with the riv nut as opposed to just a regular nut?