- Thread starter
- #21
Couple more things...Got the 4-spd bell-housing! Thanks Nick! I'm planning to blast and paint it before it gets installed. I have an IR compressor on the Christmas list this year. Hope I've been good! 
JPs Slow '74 Build Thread (1 Viewer)
- Thread starter 74HogGuy
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #22
Christmas is here! I'll be ready to do some small blasting soon!
Now to figure out how to unload this beast...
Now to figure out how to unload this beast...
Last edited:
- Thread starter
- #23
Put together my blasting cabinet and finally started to blast the 4-spd transmission parts.
- Thread starter
- #24
Primed and painted the bell housing mounts and the flywheel inspection cover.
- Thread starter
- #25
Put on a paint stripper on the bell housing. For some reason the blaster was not removing any of the paint. This stuff seems to be doing the trick. I may take some creative liberties when I repaint it.
- Thread starter
- #26
I let the stripper set a day then I took a wire wheel to it. Next just to finish basting it then I'll prime and paint.
- Thread starter
- #27
Finished blasting the outside of the bell-housing. Thought I'd go ahead and throw some primer and paint on it before it started flash rusting.
- Thread starter
- #28
Brutal day...was going to do a little blasting today to pass some dead time and 15 minutes in my hose in the blasting cabinet decide to explode. So I moved to something else monotonous...removing the PO spray in bed liner. It was coming out quicker than I thought and then I found what I was hoping NOT to find. Looks like I'll be replacing the rear sill when replace my quarters.
