I tryed one of these yesterday
- Thread starter cruiser88
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I don't wanna know what you used it on.....
I dunno Man... the camera end look too large to fit in a spark plug hole, and thats what I'd need it for...The snap-on I have has a real small end, good for looking in tight places.... you could even stick it up your butt without much discomfort ,I would imagine......
we didn't need to know that really, but whatever floats your boat....
Inquiring minds might wanna know.........
- Thread starter
- #6
No it fits
- Thread starter
- #8
Where?
Cruiser plug hole. But after looking at it again tonight there is a section a little further back from the eye that I dare call RIBBED, may not fit.But it still has a million and one uses
.
I can only think of eleventeen uses.
What are some of the others that I could use to justify this purchase to the wife?
What are some of the others that I could use to justify this purchase to the wife?
- Thread starter
- #10
- Thread starter
- #12
Yes it is quite flexable
Lol i dont like where this is going
Yea anyway you can bend it to anyshape without much effort and it will hold but then again
not to stiff.It really is a nice unit. The led"s allowed me to read the part info off a gas valve and a blower motor without taking anything apart.
- Thread starter
- #14
It is water proof up to 10 feet yes all things are inside the shaft. But it is battery operated.
??? not sure on the fiber optics question
sorry, I just meant to say/confirm that the camera is at the actual tip, not further inside with a fiber optics connection. If the former, than you would have only electrical wires inside the shaft so it could be bent sharply (although the shaft looks pretty thick, strangely). Not true with fiber optics of course.
- Thread starter
- #16
Oh ok yes the camera and the leds are both at the tip. When looking at the screen it looks like a wide screen not a tunnel vision type look. I never took it apart to ADAPT the other sections that you can attach to make it longer.
Now that is a question i am asking myself now "does the tip screw on or plug on"?
I would think it would screw on?
Now that is a question i am asking myself now "does the tip screw on or plug on"?
I would think it would screw on?
- Thread starter
- #17
Anyway I am going to buy one is i will post up the specs on it.
- Thread starter
- #19
Yea my local dude said he would let me have it for 200. He also advised me (the Rigid guy) that if i waited a few months the price would drop
.And it is made in the USA(Clevland or Erie PA) according to him
- Thread starter
- #20
Oh yea check out their PRO PRESS system
