How to reconnect kickdown cable to throttle body on a 2002 FZJ105 auto with a 1FZ-Fe engine?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 11, 2017
Threads
16
Messages
176
Location
Hobart, Tasmania, Australia
Hi all.
I recently picked up a 2002 FZJ105 series after my UZJ100 was ran into by a rather nasty Nissan Patrol... resulting in both vehicles being write-offs.
I was checking condition of the spark plugs today, and loosened off the nut on the lower of three cables running to the throttle body, which I believe is the kickdown cable, to gain better access to one of the bolts.
After checking the spark plugs, and reassembling, I realised the cable had disconnected from the throttle body.
I can't work out where it goes to reattach it.
I injured my neck a while ago, so I have limited movement, and therefore cannot get a good picture of the area, being at the very back of the engine bay.
I've tried to lean over and take photos, and videos, with my phone, but I still cannot work out where it goes.
It must attach to the rotating wheel thingy that the accelerator cable connects to, but can't see where or how to do it.
If anyone has any images of the throttle body for the 105 series, or suggestions, I'd appreciate it.
 
Last edited:

Users who are viewing this thread

Back
Top Bottom