Help install crank nut [Real time] (1 Viewer)

[airon23]

So I need to tighten the crank nut but am not sure the best way to keep the crank from turning while I try to torque it to 130.
Any tips on how to do this?

 

[fjc-man]

How about jamming a 2x4 between the flywheel teeth and the bell housing?

 

[Living in the Past]

The flywheel probably has a few holes around the edge. 12" 3/8" socket extension in one of those hole and rotate the crankshaft nut until the socket extension hits the bellhousing. Then torque away.

 

[airon23]

The flywheel probably has a few holes around the edge. 12" 3/8" socket extension in one of those hole and rotate the crankshaft nut until the socket extension hits the bellhousing. Then torque away.

Perfect thanks. Done.