I posted a thread before about two problems with the heater system
1) the fresh air cable was not connected by the PO. I bet when they did the engine rebuild. David Dearborn pointed me in the right direction how to hook it up.
2) I only had one speed (Hi) with the blower motor. zebrabeefj40 correctly told me the resistor was blown. I went to the local elctronics store and bought a 1 ohm 50 watt resistor. I had to bend the flanges down on the bracket to fit the longer replacement and used electrical tape to mount it to the bracket. I made sure one flange was touching the end of the resistor for heat disappasition. It now works at Lo and Hi speeds.
Thanks zebrabeefj40 and David.
I hate to say this, but I think I have finally fixed all the PO's issues and now everything works the way it is suppose to.
I thought I would share the results in case anyone else has a similar problem with only one speed.
1) the fresh air cable was not connected by the PO. I bet when they did the engine rebuild. David Dearborn pointed me in the right direction how to hook it up.
2) I only had one speed (Hi) with the blower motor. zebrabeefj40 correctly told me the resistor was blown. I went to the local elctronics store and bought a 1 ohm 50 watt resistor. I had to bend the flanges down on the bracket to fit the longer replacement and used electrical tape to mount it to the bracket. I made sure one flange was touching the end of the resistor for heat disappasition. It now works at Lo and Hi speeds.
Thanks zebrabeefj40 and David.
I hate to say this, but I think I have finally fixed all the PO's issues and now everything works the way it is suppose to.
I thought I would share the results in case anyone else has a similar problem with only one speed.