Some of the hard brake lines on my '95 aren't looking so great. There is some corrosion on specific spots and I am trying to figure out if it is better to replace the entire line with OEM lines or cut, flare, and add a new section the the current lines.
The lines I am looking at are:
The line going from the hard line to soft rubber line next to the front passenger wheel. This line goes up into the engine compartment and accross the entire firewall.
The other two lines run along the entire frame rail from front to back of the truck on the driver's side.
I am sure someone has replaced these in the past. Does everything along the firewall need to be removed to replace the line or can it be snaked in there and replaced?
Does the gas tank and other components need to be removed to replace the 2 lines along the drivers side frame rail?
Thanks
The lines I am looking at are:
The line going from the hard line to soft rubber line next to the front passenger wheel. This line goes up into the engine compartment and accross the entire firewall.
The other two lines run along the entire frame rail from front to back of the truck on the driver's side.
I am sure someone has replaced these in the past. Does everything along the firewall need to be removed to replace the line or can it be snaked in there and replaced?
Does the gas tank and other components need to be removed to replace the 2 lines along the drivers side frame rail?
Thanks