I’m in the middle of doing the OME lift on my 94. Front went very smooth and the rear, not so much. The 2 bolts that hold the strut bracket in place are just stripping, i’ve been pb blasting it and heating it still just stripping the bolt head.
I’m wondering if anyone has cut the strut as close to the bracket as possible, probably just slicing through the bushing from there i will fish the top part out between the strut tower and body. when it’s ready to go back together i will stack everything on the bracket, put the strut though it all carefully then finger tighten the nut. i know i can fit a 19mm on the nut on top so i will be able to torque it properly when done.
any thoughts?
I’m wondering if anyone has cut the strut as close to the bracket as possible, probably just slicing through the bushing from there i will fish the top part out between the strut tower and body. when it’s ready to go back together i will stack everything on the bracket, put the strut though it all carefully then finger tighten the nut. i know i can fit a 19mm on the nut on top so i will be able to torque it properly when done.
any thoughts?